Used for safety railing on slopes between 0° and 45°, between the top rial and an intermediate upright which is required to remain vertical. Components are held in stock as blanks and then machined to individual requirements.
Note: When used in pairs, tee will not be handed. The set screws on side will face inward on the stair or ramp. For an alternative to this fitting, see Type 29
|Fitting Type||Bore Size
(Inside of Pipe)
|Pipe For Your Structure|
Kee Klamp safety components are produced in a range of standard sizes to suit schedule 40 steel pipe, sizes 1/4" nominal to 2” nominal bore; also equivalent sizes of tubing in other materials.
Tubing of other specifications can be used, providing the outside diameter is compatible with schedule 40 pipe. Pipe with a wall thickness of less than 1/8” can only be used in lightly loaded structure.
A Kee Klamp component (size 5 – 9) can support an axial load of 2,000 lbs per set screw with the set screw tightened to a torque of 29 lbs/ft. (Rating includes a safety factor of 2:1.) This is normally obtained when the set screw is fully tightened using a ratchet wrench.