L62 - Standard Railing Flange Kee Lite Fitting

(No reviews yet) Write a Review
0.77 LBS
Calculated at Checkout
L62 - Standard Railing Flange Kee Lite Fitting

The Type L62 should always be used to fix down guardrail and blustrades. Holes are of sufficient diameter to insure proper fixing with either a mechanical or chemical anchor. The two set screws in the vertical socket give greater sideload stability to the upright. It is recommended that the fixing holes in the flange should be in line with the applied load.  The pipe is able to pass through the base of the fitting.

kee-lite-l62.jpg kee-lite-l62-drawing.jpg
Fitting Type Bore Size
(Inside of Pipe)
Pipe A
(Schedule 40)
D E F G H J Bolt Hole Dia.
L62-6 1” 6 1.97” 3.54” .35” 3.50" 5.04" 2.95" .55"
L62-7 1-1/4” 7 2.18” 3.54” .35” 4.02" 5.51" 3.23" .55"
L62-8 1-1/2” 8 2.43” 3.54” .35” 4.53" 6.30" 3.31" .55"


Pipe For Your Structure

Kee Klamp safety components are produced in a range of standard sizes to suit schedule 40 steel pipe, sizes 1/4" nominal to 2” nominal bore; also equivalent sizes of tubing in other materials.

Tubing of other specifications can be used, providing the outside diameter is compatible with schedule 40 pipe. Pipe with a wall thickness of less than 1/8” can only be used in lightly loaded structure.

A Kee Klamp component (size 5 – 9) can support an axial load of 2,000 lbs per set screw with the set screw tightened to a torque of 29 lbs/ft. (Rating includes a safety factor of 2:1.) This is normally obtained when the set screw is fully tightened using a ratchet wrench.

Videos Hide Videos Show Videos