81 - Single Sided Clip Kee Klamp Fitting

$3.27
(No reviews yet) Write a Review
SKU:
81
Weight:
0.15 LBS
Shipping:
Calculated at Checkout
81 - Single Sided Clip Kee Klamp Fitting

For attaching wire mesh in-fill.  For economy it is possible to use Type 81 clips without the safety attachment, to secure various types of infill panels (ply-board, perpex, etc.) up to a thickness of 25/64".  All clips are supplied with hexagonal head fixing bolts, M6 x 35mm long and nut.  The primary clip has a slot measuring 0.31 x 0.59".  See Types P50 and Type P57 for alternatives.

Note: For D and E dimensions the figures are given for the respective minimum and maximum dimensions allowed by the slotted hole.

kee-klamp-81.jpg kee-klamp-81-profile.jpg
Fitting Type Bore Size
(Inside of Pipe)
Pipe A
(Schedule 40)
D E F D
81-5 3/4” 5 .94” 1.77” 2.20” .28"
81-6 1” 6 1.06” 2.05” 2.32” .28"
81-7 1-1/4” 7 1.26” 2.24” 2.52” .28"
81-8 1-1/2” 8 1.34” 2.32” 2.60” .28"
81-9 2” 9 1.57” 2.56” 2.83” .28"


kee-klamp-pipe-size-new.png

Pipe For Your Structure

Kee Klamp safety components are produced in a range of standard sizes to suit schedule 40 steel pipe, sizes 1/4" nominal to 2” nominal bore; also equivalent sizes of tubing in other materials.

Tubing of other specifications can be used, providing the outside diameter is compatible with schedule 40 pipe. Pipe with a wall thickness of less than 1/8” can only be used in lightly loaded structure.

A Kee Klamp component (size 5 – 9) can support an axial load of 2,000 lbs per set screw with the set screw tightened to a torque of 29 lbs/ft. (Rating includes a safety factor of 2:1.) This is normally obtained when the set screw is fully tightened using a ratchet wrench.