63 - Angle Base Flange Kee Klamp Fitting

(No reviews yet) Write a Review
2.00 LBS
Calculated at Checkout
63 - Angle Base Flange Kee Klamp Fitting

Similar to Type 62, but used to set up the upright at an angle between 45 - 60 degrees.  This fitting should only be subjected to light loads which cannot be positioned at 90 degrees to the applied load.  For greater loads or other pipe sizes, a Type 62 flange is used and the upright bent to the required angle.

kee-klamp-63.jpg kee-klamp-63-profile.jpg

 Fitting Type

 Bore Size
(Inside of Pipe)
Pipe A
(Shedule 40)
D E F G H Bolt Hole Dia.
63-6 1” 6 3.07” 5.12” 3.62” 3.78" .31" .55"
63-7 1-1/4” 7 2.99” 5.43” 3.74” 4.17" .39" .55"
63-8 1-1/2” 8 3.54” 6.10”  3.94” 5.43" .39" .55"


Pipe For Your Structure

Kee Klamp safety components are produced in a range of standard sizes to suit schedule 40 steel pipe, sizes 1/4" nominal to 2” nominal bore; also equivalent sizes of tubing in other materials.

Tubing of other specifications can be used, providing the outside diameter is compatible with schedule 40 pipe. Pipe with a wall thickness of less than 1/8” can only be used in lightly loaded structure.

A Kee Klamp component (size 5 – 9) can support an axial load of 2,000 lbs per set screw with the set screw tightened to a torque of 29 lbs/ft. (Rating includes a safety factor of 2:1.) This is normally obtained when the set screw is fully tightened using a ratchet wrench.

Videos Hide Videos Show Videos