328 - Two Socket Custom Cross Kee Klamp Fitting

(No reviews yet) Write a Review
2.75 LBS
Calculated at Checkout
328 - Two Socket Custom Cross Kee Klamp Fitting

Used for safety railing on slopes between 11 and 30 degrees, between the midrail and an intermediate upright which is required to remain vertical. These fittings are held in stock as blanks which are machined to individual requirements. Special order only: please specify required angle.

Note: When used in pairs, Tee will not be handed.  The set screws on one side will face inward on the stair or ramp.  For an alternative to this fitting, see Type 30.

kee-klamp-328.jpg 28-t.jpg
Fitting Type Bore Size
(Inside of Pipe)
Pipe A
(Schedule 40)
328-7 1-1/4” 7 7.48”
328-8 1-1/2” 8 8.50”


Pipe For Your Structure

Kee Klamp safety components are produced in a range of standard sizes to suit schedule 40 steel pipe, sizes 1/4" nominal to 2” nominal bore; also equivalent sizes of tubing in other materials.

Tubing of other specifications can be used, providing the outside diameter is compatible with schedule 40 pipe. Pipe with a wall thickness of less than 1/8” can only be used in lightly loaded structure.

A Kee Klamp component (size 5 – 9) can support an axial load of 2,000 lbs per set screw with the set screw tightened to a torque of 29 lbs/ft. (Rating includes a safety factor of 2:1.) This is normally obtained when the set screw is fully tightened using a ratchet wrench. 

Videos Hide Videos Show Videos